Page 2 of 2 FirstFirst 12
Results 21 to 30 of 30

Dodge=dump - Page 2

| A Day in the Life of a Scrapper
  1. #21
    Sirscrapalot's Avatar
    SMF Badges of Honor


    Member since
    Mar 2012
    Location
    A sandbar off the atlantic..OBX,NC
    Posts
    6,123
    Thanks
    11,885
    Thanked 8,781 Times in 3,853 Posts
    Wayne can correct me if I'm wrong, but..Hot shotting is basically running a load somewhere that needs it ASAP. Whether it's oil field stuff, car parts, etc. Expediting, is similar to trucking, but you use straight trucks, an cargo vans. Your also hauling butt to places, just not as fast..lol.

    So in short...Hot shot = Time sensitive loads Expedite = Small loads, that a 18 wheeler is over kill for. Hence the use of straight trucks an Vans.

    Hope that helps, an thanks Wayne, will shoot ya a pm here in the future, an pick your brain.

    Sorry OP!



    Sirscrapalot - Youth is wasted on the young. - George Bernard Shaw.


  2. #22
    wayne1956's Avatar
    SMF Badges of Honor



    Member since
    Aug 2010
    Location
    Cleburne, TX
    Posts
    705
    Thanks
    195
    Thanked 754 Times in 293 Posts
    A lot of that is correct, but it is not quite the "gotta get it there ASAP" anymore like it use to be. Basically hotshotting is a non-dedicated form of delivery, meaning you are not working a dedicated route and are not necessarily working for one specific company. It basically is a one time delivery from point A to point B for a company who usually does not have their own transportation delivery system. Quite often I picked up loads on Thursday that did not have to be there until Monday morning, and it was not but a couple hundred miles or so away. Probably one of the hardest things about hotshotting is getting "backhauls" (a load from somewhere near the place you just delivered back somewhere near home so you can get paid coming back also). Deadheading (going back home without a load) really sucked because you were spending money out of your pocket for fuel without an expectation of any return since you do not have a load. I subcontracted to a company that set up all my runs for me. While I was going from point A to point B, they were busy looking for me a run from point B back home to point A, or from point B to point C. I did not have to worry about getting on the load boards to find a run, they were doing it for me, I just had to concentrate on load I had. There are a lot of hotshotters out there with the big rigs also, as companies have one time loads of 20 - 40 tons they need delivered, and the trailer I had could only carry a max load of 8 tons. There are a lot of long hours in it, but it can pay pretty well, just depends on what a person wants to put into it. That being said, there are a lot of regulations also, you have to follow pretty much all of the DOT regulations the heavy haulers have to follow. Some of them are a pain, but it is what it is, and you go into it knowing about it so you just deal with it. I enjoyed a lot of it (seeing country I normally would not have seen, being my own boss, working outside) and a lot I did not enjoy (big city traffic jams (AUSTIN SUCKED!!!), securing loads in 100+ degree weather, tarping in rain or winds). Hope this answered some questions anyone might have.

    Ouch, sorry the post was so long, did mean to ramble on this long.
    Last edited by wayne1956; 02-17-2014 at 09:02 AM.

  3. The Following User Says Thank You to wayne1956 for This Post:


  4. #23
    Sirscrapalot's Avatar
    SMF Badges of Honor


    Member since
    Mar 2012
    Location
    A sandbar off the atlantic..OBX,NC
    Posts
    6,123
    Thanks
    11,885
    Thanked 8,781 Times in 3,853 Posts
    Good post Wayne, an thanks for the clarifying it better then I did. I just went with the down an dirty. Heh.

    I'll refrain from derailing this thread any longer, or I'ma owe the OP my whole cooler! lol.

    Sirscrapalot - Above all things, I must not get angry. If I do get angry I knock all the teeth out of the mouth of the poor wretch who has angered me. - Franz Schubert

  5. #24
    wayne1956's Avatar
    SMF Badges of Honor



    Member since
    Aug 2010
    Location
    Cleburne, TX
    Posts
    705
    Thanks
    195
    Thanked 754 Times in 293 Posts
    And I too owe an apology to the OP, I did not mean to get so far off topic.

  6. #25
    NotSoBadDan started this thread.
    NotSoBadDan's Avatar
    SMF Badges of Honor

    Member since
    Jan 2014
    Location
    Indiana
    Posts
    35
    Thanks
    2
    Thanked 24 Times in 14 Posts

    Dodge=dump

    Its all good fellas!

  7. The Following User Says Thank You to NotSoBadDan for This Post:


  8. #26
    SMF Badges of Honor



    Member since
    Jan 2011
    Posts
    1,159
    Thanks
    0
    Thanked 248 Times in 169 Posts
    so op dont you think it would be cheaper to fix that than to buy another truck?

  9. #27
    NotSoBadDan started this thread.
    NotSoBadDan's Avatar
    SMF Badges of Honor

    Member since
    Jan 2014
    Location
    Indiana
    Posts
    35
    Thanks
    2
    Thanked 24 Times in 14 Posts

    Dodge=dump

    In all reality yes, I may fix it and only use it for scrapping. Its not worth anything resell interior is junk, its rusting something awful, and well, it has all sorts of issues haha.

  10. #28
    SMF Badges of Honor



    Member since
    Jan 2011
    Posts
    1,159
    Thanks
    0
    Thanked 248 Times in 169 Posts
    well if it is junk then i would move on lol.

  11. #29
    MattInTheHat's Avatar
    SMF Badges of Honor


    Member since
    Sep 2012
    Location
    rock hill, sc
    Posts
    1,464
    Thanks
    1,142
    Thanked 1,396 Times in 703 Posts

    Dodge=dump

    dead on driveway get explosives
    Currently looking for a job in or related to scrap/recycling. Relocation is possible for the right offer.

  12. The Following User Says Thank You to MattInTheHat for This Post:


  13. #30
    SMF Badges of Honor

    Member since
    Jul 2011
    Location
    Memphis, TN
    Posts
    117
    Thanks
    11
    Thanked 25 Times in 21 Posts
    Quote Originally Posted by Kochy View Post
    Sorry to go off topic here, but what is hotshotting? You mean like shipping things cross country kind of like Uship? That's the picture that I'm seeing.
    Yes, you kind of have it; Hotshotting is the one who carrys the loads; does the driving, etc.


  14. Similar threads on the Scrap Metal Forum

    1. Dodge 4x4
      By Copper Head in forum A Day in the Life of a Scrapper
      Replies: 13
      Last Post: 01-08-2014, 05:52 PM
    2. dodge dakotas
      By corycouch in forum Vehicle Recycling
      Replies: 3
      Last Post: 04-08-2013, 01:03 AM
    3. Ford, Chevy, Dodge or whatever?
      By Sprocket in forum Off Topic Discussions
      Replies: 10
      Last Post: 02-15-2013, 09:16 PM
    4. Dodge ECM Gold Pins
      By joef1812 in forum Vehicle Recycling
      Replies: 14
      Last Post: 07-24-2012, 10:15 AM

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook