Results 1 to 8 of 8

Weird wire insulated with Lead

| A Day in the Life of a Scrapper
  1. #1
    pappawheelie started this thread.
    pappawheelie's Avatar
    SMF Badges of Honor

    Member since
    Apr 2013
    Location
    WI
    Posts
    94
    Thanks
    69
    Thanked 148 Times in 48 Posts

    Weird wire insulated with Lead

    Picked up a small load the other day that included some 1" conduit apparently from an old underground service.
    Looked like two runs of Romex inside the pipe but on closer inspection it was ....gray and soft.....LEAD insulation !
    Added up to 101' of wire, about 30#. I stripped it by just slicing it down the center with a sharp utility knife.
    Ended up with 8# of #1 insulated and 22# of lead. YeeHaa......sure beats throwing the insulation into the trash!!!
    Dealt with a lot of wire over the years but this was my first "leaded" wire. Wonder how old this stuff is?

    Attached Images Attached Images     

  2. The Following 10 Users say Thank You for This Post by pappawheelie:



  3. #2
    travistemple202020's Avatar
    SMF Badges of Honor


    Member since
    Jul 2012
    Location
    ames iowa
    Posts
    1,326
    Thanks
    267
    Thanked 883 Times in 495 Posts
    never came across it before but that would have been a heavy surprise

  4. #3
    SMF Badges of Honor

    Member since
    Feb 2015
    Location
    South East Missouri
    Posts
    64
    Thanks
    9
    Thanked 22 Times in 13 Posts
    I have only seen that with large phone wires. Talking the bundles that are 3"-4" in diameter. They had a lead shielding around them but they were buried directly and not in conduit. Place I used to work melted off the lead in a sweat furnace and then sent the copper off. Now the trick is to find a bunch more and send it my way.
    Last edited by bajacoop; 05-05-2015 at 11:10 AM.

  5. #4
    Abuilder's Avatar
    SMF Badges of Honor


    Member since
    Apr 2012
    Location
    SE Wisconsin
    Posts
    436
    Thanks
    228
    Thanked 487 Times in 251 Posts
    Pappaw
    Thanks for the pictures. That must have been the very early version of burial cable.
    I only get #2 insulated for that rubber/cotton insulated wire even if it is 12 gauge.
    Last edited by Abuilder; 05-05-2015 at 04:35 PM.

  6. #5
    hobo finds's Avatar
    SMF Badges of Honor


    Member since
    Nov 2010
    Location
    tucson, az
    Posts
    4,758
    Thanks
    6,037
    Thanked 5,910 Times in 2,556 Posts
    I would get #2 insulated for it as well, and would remove the lead as well. Cool find!

  7. #6
    dsroten's Avatar
    SMF Badges of Honor


    Member since
    Apr 2015
    Location
    NC, United States
    Posts
    83
    Thanks
    25
    Thanked 141 Times in 50 Posts
    I'm jealous. I like lead, making "boolits" is fun stuff

  8. #7
    DakotaRog's Avatar
    SMF Badges of Honor



    Member since
    Aug 2014
    Posts
    1,611
    Thanks
    602
    Thanked 1,675 Times in 830 Posts
    Cool! Sell it quick before the EPA comes after you for having lead

  9. #8
    submarinepainter's Avatar
    SMF Badges of Honor



    Member since
    Sep 2011
    Location
    Maine
    Posts
    1,025
    Thanks
    1,230
    Thanked 654 Times in 316 Posts
    always wear gloves and throw them out after handling lead , washing your hands before you eat or smoke.
    Old dogs care about you even when you make mistakes;
    God bless little children while they're still too young to hate


  10. Similar threads on the Scrap Metal Forum

    1. Insulated Wire Tip
      By MetalRecycler in forum Scrap Metal Tips and Advice
      Replies: 32
      Last Post: 10-29-2022, 07:37 AM
    2. #2 insulated wire with ends on
      By hobo finds in forum Scrap Metal Prices
      Replies: 5
      Last Post: 09-20-2018, 05:29 PM
    3. What's insulated copper wire going for near you
      By redcrossnj in forum Scrap Metal Questions and Answers
      Replies: 22
      Last Post: 12-01-2014, 01:17 PM
    4. insulated wire
      By randysgirl in forum Scrap Metal Questions and Answers
      Replies: 2
      Last Post: 03-15-2013, 08:13 PM
    5. Insulated copper wire
      By copperhound in forum Scrap Metal Questions and Answers
      Replies: 17
      Last Post: 04-11-2012, 05:38 AM

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook