Metal Recycling Entrepreneur
This project is going much slower than anticipated, here's a dummy pilot shaft that I turned from wood then soaked in boiled linseed oil. The dummy shaft will help align the clutch disk during installation.
The old clutch was fairly decent but showed signs of wear on the old disk which was not really intended for tractor use with a PTO not equipped with an over run clutch, this solid disk is an improvement.
Last edited by alloy2; 06-09-2017 at 09:52 PM.
There are currently 1 users browsing this thread. (0 members and 1 guests)
|
Browse the Most Recent Threads
On SMF In THIS CATEGORY. 
OR 
|
Posting Permissions
Bookmarks