Page 1 of 2 12 LastLast
Results 1 to 20 of 28

Anyone know plumbing?

| Off Topic Discussions
  1. #1
    ComputerScrapper started this thread.
    ComputerScrapper's Avatar
    SMF Badges of Honor


    Member since
    Mar 2011
    Location
    Portland, Indiana
    Posts
    497
    Thanks
    18
    Thanked 320 Times in 145 Posts

    Anyone know plumbing?

    Ok so I got up this morning and the crapper won't flush, the bathroom sink won't drain and the shower won't drain. Just great.

    Here is the problem...I know less than zero about plumbing...I know that water flows through pipes and that is about it....I was told to get a snake so I did but I don't know where I should put it.....The guy at the store said I should run it down through the toilet but he was wearing a shirt that said "I am GaGa for Lady GaGa" so trusting his judgement is not something I am prepared to do. (Let me apologize upfront to all the Lady GaGa fans on the forum)

    So any ideas would be extremely helpful.
    Currently Buying E-Scrap
    Visit http://www.wastenotecycling.com for more details.

    "A good jockey sits straight up on the horse....Otherwise your boobs flop around and get caught in your back fat." Betty White


  2. #2
    SMF Badges of Honor


    Member since
    Nov 2011
    Location
    boise, ID
    Posts
    1,605
    Thanks
    469
    Thanked 1,462 Times in 668 Posts
    A toilet snake isn't going to help. You either have a frozen or plugged trunk line.

  3. #3
    SMF Badges of Honor


    Member since
    May 2011
    Location
    Dallas TX
    Posts
    1,979
    Thanks
    158
    Thanked 1,182 Times in 518 Posts
    I was a pipe fitter and worked on power plants...what he said is right...you run it down the toilet and twist it around and keep snaking it down. When it finds what is clogging the pipes it will rip it apart and will drain once again.

    Now in another bathroom or even the kitchen is the sink or other drains working? If not you need to go outside to the outside ports...there will be to pipes out in front (close to the house) one will be close..that one goes to the city...the out away from your house goes to your house...run it to your house first and see if you feel any blockage...if none found then it could be on the city side and so you put it into the other port and do the same.

    If you need more help just drop another line.
    My company name was Easy Recycle but has since been closed
    My Name Stephan Harz
    My YouTube page

  4. #4
    ComputerScrapper started this thread.
    ComputerScrapper's Avatar
    SMF Badges of Honor


    Member since
    Mar 2011
    Location
    Portland, Indiana
    Posts
    497
    Thanks
    18
    Thanked 320 Times in 145 Posts
    Quote Originally Posted by freonjoe View Post
    A toilet snake isn't going to help. You either have a frozen or plugged trunk line.
    Alrighty then...How does one go about unplugging or unfreezing a trunk line? And what is a trunk line? This is starting to sound much like a job for someone that has actual skill in this department.

  5. #5
    ComputerScrapper started this thread.
    ComputerScrapper's Avatar
    SMF Badges of Honor


    Member since
    Mar 2011
    Location
    Portland, Indiana
    Posts
    497
    Thanks
    18
    Thanked 320 Times in 145 Posts
    Quote Originally Posted by easyrecycle View Post
    I was a pipe fitter and worked on power plants...what he said is right...you run it down the toilet and twist it around and keep snaking it down. When it finds what is clogging the pipes it will rip it apart and will drain once again.

    Now in another bathroom or even the kitchen is the sink or other drains working? If not you need to go outside to the outside ports...there will be to pipes out in front (close to the house) one will be close..that one goes to the city...the out away from your house goes to your house...run it to your house first and see if you feel any blockage...if none found then it could be on the city side and so you put it into the other port and do the same.

    If you need more help just drop another line.
    The kitchen works just fine, both the sink and the dishwasher....The washer will not drain but it is run right into the drain line for the bathroom sink so that is common sense.

  6. #6
    SMF Badges of Honor


    Member since
    May 2011
    Location
    Dallas TX
    Posts
    1,979
    Thanks
    158
    Thanked 1,182 Times in 518 Posts
    Quote Originally Posted by freonjoe View Post
    A toilet snake isn't going to help. You either have a frozen or plugged trunk line.
    a toilet snake can help if the blockage is close.

    The pipe being frozen is not very likely as when they are setting the lines they are put deep into the ground to prevent this. What happens more often is that a large tree sent larger roots into the piping system and blocked it up. So you would want a saw type snake.

    All black lines will have roots in them unless its a new pipe line. This tho is not an issue half the time unless during a time with no rain...the trees will find water and will send larger roots that can brake and plug the lines up

  7. #7
    SMF Badges of Honor


    Member since
    Nov 2011
    Location
    boise, ID
    Posts
    1,605
    Thanks
    469
    Thanked 1,462 Times in 668 Posts
    Do you have any friends that do property maintainance? They might have a power snake you could borrow and walk you through using it. A trunk line feeds your main line. Is that the only bathroom you're having problems with?

  8. #8
    SMF Badges of Honor


    Member since
    May 2011
    Location
    Dallas TX
    Posts
    1,979
    Thanks
    158
    Thanked 1,182 Times in 518 Posts
    Quote Originally Posted by ComputerScrapper View Post
    The kitchen works just fine, both the sink and the dishwasher....The washer will not drain but it is run right into the drain line for the bathroom sink so that is common sense.
    Then run it on the toilet and start from there. If you are unable to find where its plugged up you maybe able to go where the washer dumps in and see if you can find it there.

    The dishwasher is piped into the kitchen sink..or should be.

  9. #9
    SMF Badges of Honor


    Member since
    May 2011
    Location
    Dallas TX
    Posts
    1,979
    Thanks
    158
    Thanked 1,182 Times in 518 Posts
    Quote Originally Posted by injunjoe View Post
    Have you seen a cleanout outside the house? If you can find a cleanout you may be able to snake it out from there.

    Is it gurgling when the sink tries to drain? If so it could be a vent clogged up.

    Are you on sewer or septic? Septic may be full of solids and need pumped out. The baffle may have rotted allowing solids to back into the inlet or be blocking up leach field. Or worse case the leach field needs replaced.
    The other sinks are working so he should not need to go outside to the clean out ports.

    Cant be a septic issue as other sinks will drain just fine..its just that one bathroom so it is a line that has a blockage. Question is if his snake can reach it or not.

  10. #10
    injunjoe's Avatar
    SMF Badges of Honor



    Member since
    Jan 2011
    Location
    Central, FL
    Posts
    1,309
    Thanks
    1,249
    Thanked 1,194 Times in 594 Posts
    I was typing when that was post so I removed my reply as the answers were answered!

    Bad timing!

    It could still be a roof vent!
    When the white man discovered this country Indians were running it
    no taxes, no debt, women did all the work.
    White man thought he could improve on a system like this. - Old Cherokee saying

    I did not surrender, they took my horse and made him surrender. - Lone Watie

  11. #11
    KzScrapper's Avatar
    SMF Badges of Honor


    Member since
    Apr 2011
    Location
    Denver Metro, CO
    Posts
    4,841
    Thanks
    7,019
    Thanked 5,792 Times in 2,417 Posts
    Run the snake down the toilet to start (like Easy said) The pipe for the toilet is usually 4" so it has to go to a one of the trunks. Good chance something went down the toilet and is clogging things and if your snake is long enough it should bust thru. Take it slow and spin the snake as your trying to feed it thru the s-turn in the toilet.
    Recyclable Material Merchant Wholesaler
    Certified Zip-Tie Mechanic
    "Give them enough so they can do something with it, but not too much that they won't do nothing."

  12. #12
    SMF Badges of Honor


    Member since
    May 2011
    Location
    Dallas TX
    Posts
    1,979
    Thanks
    158
    Thanked 1,182 Times in 518 Posts
    Quote Originally Posted by injunjoe View Post
    I was typing when that was post so I removed my reply as the answers were answered!

    Bad timing!

    It could still be a roof vent!
    Roof vent could be something but I hardly have ever seen them plugged up...but then again I have not really worked on houses but power plants and what not.

    Yea this thread JUMPED with alot of good posts that some where over lapping lmao

  13. #13
    ComputerScrapper started this thread.
    ComputerScrapper's Avatar
    SMF Badges of Honor


    Member since
    Mar 2011
    Location
    Portland, Indiana
    Posts
    497
    Thanks
    18
    Thanked 320 Times in 145 Posts
    Okay update time....I ran the snake down the toilet and it came loose....That is the good news....The shower and the toilet now work...However, the bathroom sink is still not working and the water is coming up through the vent pipe when I run the bathroom sink....I know this because they ran the vent through the bathroom and there is a port on it and the water is pouring out. I have tried running the snake down through the bathroom sink drain line (I took off the trap before trying this to save snake line) and it comes to something and just stops...Does not feel like a plug and I have tried several different times to get it through and it just won't move any further....

  14. #14
    SMF Badges of Honor


    Member since
    Jan 2012
    Location
    VA
    Posts
    52
    Thanks
    2
    Thanked 19 Times in 17 Posts
    What type of pipe do you have? Cast Iron, Copper, ABS, or PVC? If you want to use a chemical, the type of pipe you have will decide which type to use.

  15. #15
    ComputerScrapper started this thread.
    ComputerScrapper's Avatar
    SMF Badges of Honor


    Member since
    Mar 2011
    Location
    Portland, Indiana
    Posts
    497
    Thanks
    18
    Thanked 320 Times in 145 Posts
    PVC is the pipe....Failed to mention that we tried the chemicals in it and they just poured out through the vent pipe....The guy with the Lady GaGa shirt said we should buy some of that as well.

  16. #16
    SMF Badges of Honor


    Member since
    Jan 2012
    Location
    VA
    Posts
    52
    Thanks
    2
    Thanked 19 Times in 17 Posts
    There is a product called "Drain King". It uses your garden hose to put water pressure into the pipe and bust the stoppage loose. These are great tools, but you can not have any openings between it and the stoppage. Which means plugging one or two of the outlets. Plugging can be by means of a "Dollar Plug" or a threaded cap or plug.
    Your vent....where does it vent to?


  17. #17
    SMF Badges of Honor


    Member since
    May 2011
    Location
    Dallas TX
    Posts
    1,979
    Thanks
    158
    Thanked 1,182 Times in 518 Posts
    Run the snake up to that point and just keep turning it...push in and out and turning all at the same time...it should brake free.

    p.s that sounds so wrong if you read that to your self...but trust me i was not trying to make it sound dirty lmao

  18. #18
    ComputerScrapper started this thread.
    ComputerScrapper's Avatar
    SMF Badges of Honor


    Member since
    Mar 2011
    Location
    Portland, Indiana
    Posts
    497
    Thanks
    18
    Thanked 320 Times in 145 Posts
    It vents out through the crawl space.

  19. #19
    SMF Badges of Honor


    Member since
    Jan 2012
    Location
    VA
    Posts
    52
    Thanks
    2
    Thanked 19 Times in 17 Posts
    Ok, So you have a crawl space....You should be able to see the pipe and with measurements, tell where your stoppage is. PVC is easy to repair. Cut it out with a saw and clean it out and put it back together with "Fernco" fittings.

  20. #20
    KzScrapper's Avatar
    SMF Badges of Honor


    Member since
    Apr 2011
    Location
    Denver Metro, CO
    Posts
    4,841
    Thanks
    7,019
    Thanked 5,792 Times in 2,417 Posts
    Vent system sounds a little strange if venting in the crawl space and below the bathroom. Typical vent goes up thru the roof or a Studor vent is used in the area but both would be above pipes that are draining.



Page 1 of 2 12 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook