Page 2 of 2 FirstFirst 12
Results 21 to 29 of 29

Is overfilling an engine with oil ethical? - Page 2

| Scrap Business Ethics
  1. #21
    Kochy's Avatar
    SMF Badges of Honor

    Member since
    Jul 2012
    Location
    Sunbury, PA
    Posts
    532
    Thanks
    214
    Thanked 276 Times in 138 Posts
    Thats not bad to put oil in the engines, I've heard a lot of storys of how people put liquid cement into the engines, into the gas tanks and even put them in the tires somehow. Then also about water. Taking the gas out of the tank and refilling it with water and all that crap. Putting cinder blocks in the trunk too I've heard. All those unethical ways.

    Owner/Operator @ Stepside Recycling & Refurbishing co.


  2. #22
    jord0690's Avatar
    SMF Badges of Honor


    Member since
    Sep 2012
    Location
    Barrie
    Posts
    1,180
    Thanks
    27
    Thanked 716 Times in 440 Posts
    Quote Originally Posted by Kochy View Post
    Thats not bad to put oil in the engines, I've heard a lot of storys of how people put liquid cement into the engines, into the gas tanks and even put them in the tires somehow. Then also about water. Taking the gas out of the tank and refilling it with water and all that crap. Putting cinder blocks in the trunk too I've heard. All those unethical ways.
    Iv seen a guy load anb old cast iron fireplace full of bricks. All I hear is "ohhh sh*t mr whoever put cinder blocks in a fireplace again!"
    If I didn't have bad luck, I'd have no luck at all...

    GC Metal Recycling & Recovery
    Barrie, Ontario.

  3. The Following User Says Thank You to jord0690 for This Post:


  4. #23
    hobo finds's Avatar
    SMF Badges of Honor


    Member since
    Nov 2010
    Location
    tucson, az
    Posts
    4,758
    Thanks
    6,037
    Thanked 5,910 Times in 2,556 Posts
    I still wonder the total weight of fluids in a vehicle. What is the average? Gas, brake fluid, transmission fluid, antifreeze, wiper fluid, etc....

  5. #24
    SMF Badges of Honor



    Member since
    Jan 2011
    Posts
    1,159
    Thanks
    0
    Thanked 248 Times in 169 Posts
    i honestly dont thin it is going to make much of a difference.What does a quart weigh say 1 lbs.Well that got you a extra $0.12 lol.Oh lord you may get rich by doing that lol.

  6. #25
    TheRecycler's Avatar
    SMF Badges of Honor


    Member since
    Jan 2013
    Location
    Ithaca, NY
    Posts
    616
    Thanks
    31
    Thanked 413 Times in 199 Posts
    Quote Originally Posted by Mick View Post
    I'm hoping to start a discussion not a snipe-fest. Let's stipulate that a yard does not require oil to be drained. Would you consider overfilling an engine with used oil as unethical? Any other practices that would fall under "unethical"? If you are a yard owner/employee, please specify that. If you disagree with a poster, please state your reasoning.
    Very unethical. We are entrepreneurs of class and decent standards, at least I thought. If the yard was good to me, I wouldn't do it. But if the yard nickels and dimes, hell yea. To break even, I may have filled a 40 gallon water heater with water, I'm just saying, maybe.
    Your Trash-My Cash
    Yours Truly, TheRecycler:
    RecycleReuseItAll@Facebook.com

  7. #26
    hobo finds's Avatar
    SMF Badges of Honor


    Member since
    Nov 2010
    Location
    tucson, az
    Posts
    4,758
    Thanks
    6,037
    Thanked 5,910 Times in 2,556 Posts
    People who cheat the system get caught! Bricks and cement will do that!!!!!

  8. The Following User Says Thank You to hobo finds for This Post:


  9. #27
    SMF Badges of Honor

    Member since
    Apr 2014
    Posts
    15
    Thanks
    8
    Thanked 25 Times in 9 Posts
    The fact that this is even a question baffles me. I work for a family owned recycling yard, while we do not require autos to be "dry" we do require the gas tank be removed and empty. We still purchase the tank, just keep it empty. You are not "lining our pockets" by adding extra fluids. Depending on where you are located you can resell used oil, under pretty strict guidelines, ultimately it becomes negligible, doesn't make or break a yard. However, we are not fortunate enough to have this service available to us, too far away, fuel price negates any profit, therefore we are forced to pay for someone to come remove our used fluids. All of this is however not the biggest concern. We're regulated by laws from the EPA, if that overfilled car leaks into the ground and the EPA shows up (they don't announce their visits) we can be slapped with a huge fine, not to mention can be ordered to shut the doors. We don't make the customer drain all the oil because we want to make it easier and better for you, draining all the oil takes time, especially if you do it the proper way, we do that part for you, we consider it a cost of business. To try and sneak more in is deceitful at best. It isn't about the money, it's about not taking advantage of someone that may be helping you.
    Last edited by LordMallard; 04-03-2014 at 09:23 PM.

  10. The Following 3 Users say Thank You for This Post by LordMallard:


  11. #28
    F350scrapper's Avatar
    SMF Badges of Honor


    Member since
    May 2014
    Location
    Minnesota
    Posts
    156
    Thanks
    71
    Thanked 151 Times in 68 Posts
    Not at all the yard should realize that their policy allows for extra money they have to shell out for non metal. With this knowledge they can change the real at anytime but for the time being they are accepting it so why not make more money???

  12. #29
    MattInTheHat's Avatar
    SMF Badges of Honor


    Member since
    Sep 2012
    Location
    rock hill, sc
    Posts
    1,464
    Thanks
    1,142
    Thanked 1,396 Times in 703 Posts
    The yard i take vehicles to is a pick and pull. The owner is quite a business man, I would not be surprised if he is making money off scrap tires.

    Because I have a friend that is a mechanic, I know there are companies that buy used fluids for recycling in the area. Waste oil furnaces are also a big thing in the auto shops around here.

    I think this falls into the category of it depends on how your yard handles the fluids. I get better than shred price with fluids intact.
    Currently looking for a job in or related to scrap/recycling. Relocation is possible for the right offer.

  13. The Following User Says Thank You to MattInTheHat for This Post:



  14. Similar threads on the Scrap Metal Forum

    1. Car Engine
      By WMSTR in forum Scrap Metal Tips and Advice
      Replies: 16
      Last Post: 06-22-2021, 11:51 AM
    2. Aircraft Turbine Engine - Jet Engine Recycling & Buyers
      By Aeroturbinetech in forum Introduce yourself
      Replies: 2
      Last Post: 08-08-2019, 08:53 PM
    3. "Ethical" question about CRT monitors
      By scraplington in forum Dismantling, Breaking Down & Maximizing Scrap
      Replies: 2
      Last Post: 02-20-2013, 02:36 PM
    4. I got my first engine block...
      By xhalt in forum Vehicle Recycling
      Replies: 3
      Last Post: 12-13-2012, 06:53 PM
    5. What to do with a whole car engine?
      By Richard in forum Vehicle Recycling
      Replies: 5
      Last Post: 04-12-2011, 09:50 AM

Page 2 of 2 FirstFirst 12

Thread Information

Users Browsing this Thread

There are currently 11 users browsing this thread. (0 members and 11 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook