Experienced Scrapper
The end cap on these motors appear to be cast aluminum is this corrcect? However I noticed on a few of them when I run a magnet over some of the around the hole in the end cap where the shaft protrudes that the magnet sticks. Is this coated someway. Nothing appeared to be pressed on. So niow I am wondering if I am better off breaking the endcap in bits to try to separate for a higher price?
Almost all motors have bearings in the end caps. Cheaper motors have pressed in bushings.
Some of the motors with ball bearings will have a bearing race a few thousands of an inch thick pressed into the end cap.
Last edited by freonjoe; 02-19-2012 at 07:43 PM.
|
Yes cast alum. Check the prices for whole motors first and then see if it is worth it for you to break them down!
Thornton Scrapper
|
Every pool motor i came across has alum windings in there
|
Those will definetly have alum windings. Remember they are POOL motors. Have to hold up to outside weather and constant water on them.
I won't be wronged. I won't be insulted. I won't be laid a-hand on. I don't do these things to other people, and I require the same from them.” John Wayne-- The Shootist
NEWBS READ THIS THREAD ABOUT REFINING!!!!
http://www.scrapmetalforum.com/off-t...ning-read.html
Experienced Scrapper
Seems to me the best bet then is to scrap the motors whole because the windings are aluminum and many of the endcaps have a pressed bearing. I am assuming this prevents getting the aluminum price for the endcap. A shame as I have a steady source for pool motors. On the good side they do have pretty good weight to them.
Any thoughts to the contrary or a different take?
Have you actually verified that the windings are coated aluminum?
Only scrapped 1 pool pump motor and i can tell you the windings were copper.Diffidently verify each one.
Experienced Scrapper
I've scrapped three, all from commercial pools and hot tubs, the windings in all three were copper. The last one was an A.O. Smith 2hp bolted to a hayward super pump II, fair amount of work to break it down , but worth it to me.
Experienced Scrapper
I snipped through the windings on a couple I was breaking down and it appeared to have alu. look in the center all though the guage of the wire is pretty small. Does it make any difference if the motor is an above ground motor or not? I do have a couple of the larger 2 horse motors. Also does the pressed in bearing or coated bearing keep you from receiving the cast alu price on the end caps?
Experienced Scrapper
|
Yes on the end caps with steel in them. Just smack it with a drift and ball peen hammer. They come right out with some persuasion.
Windings can look copper and be Aluminum and vise a verse. I have a dental pick that has a hook with an edge, I reach into a motor and pick out one wire. An aluminum wire will pull out and cut very easy. No disassembly required, well just enough to get to windings.
When the white man discovered this country Indians were running it
no taxes, no debt, women did all the work.
White man thought he could improve on a system like this. - Old Cherokee saying
I did not surrender, they took my horse and made him surrender. - Lone Watie
|
Thanks everyone I got a pool motor a while back and never got to it looks like I can just take it in!!
Old dogs care about you even when you make mistakes;
God bless little children while they're still too young to hate
There are currently 3 users browsing this thread. (0 members and 3 guests)
|
Browse the Most Recent Threads
On SMF In THIS CATEGORY. 
OR 
|
Posting Permissions
Register To Reply
Bookmarks