Engine is a 1971 Datsun 74 cubic inch 70hp. Generator is WW2 AIRPLANE Westinghouse 24volt 200 amp, my cousin used to weld with it back in the day, had it hooked up to a 25hp Wisconsin v4. Main frame is 2x1 channel. Got the engine mounts and generator mounts done today and started on the hoop frame to cover it all up. I have a rheostat but will need to make an arc stabilizer for it. Plan on also running an AC generator off the front and an air compressor, thus the mile of room up front of the engine, may shorten the skid a little, will see soon. Here are some crappy pics I took with my cell phone.














I am going to run flange bearing on the tranny input shaft to keep it dead center and take away the side play. Will have to get it machined and a sleeve put on the shaft to make it longer.