Results 1 to 4 of 4

Glass shower doors that shatter to smythereens

| Scrap Metal Safety and Hazards
  1. #1
    Lazen started this thread.
    SMF Badges of Honor

    Member since
    Jun 2018
    Posts
    26
    Thanks
    5
    Thanked 9 Times in 7 Posts

    Glass shower doors that shatter to smythereens

    Watch if your doing doors and moving glass shower doors
    around.
    The slightest jolt they can shatter to smythereens.
    Safety glass granted but wouldnt want your face near them when it happens.
    Also watch out for cutting hydrolic air cables if you would
    do such a thing.
    very nasty blast of compressed air,can cause injury eg to face
    very dangerous.
    hope ive helped

  2. The Following User Says Thank You to Lazen for This Post:



  3. #2
    SMF Badges of Honor


    Member since
    Dec 2017
    Location
    Tucson AZ
    Posts
    361
    Thanks
    306
    Thanked 579 Times in 231 Posts
    Don't eat the yellow snow


  4. The Following User Says Thank You to 520 for This Post:


  5. #3
    auminer's Avatar
    SMF Badges of Honor



    Member since
    Nov 2012
    Location
    Allen, TX
    Posts
    1,233
    Thanks
    579
    Thanked 2,301 Times in 857 Posts
    Funny, I've had the opposite problem.

    When I find a shower door I load it on the truck & bring it home.

    I have an old fairly thick sheet I keep just for these. I lay the sheet flat on the back driveway and put the shower door on edge and fold the sheet up around it like a taco,

    Whack with a hammer... nothing. WHACK with a hammer... nothing. WHACK with a hammer... nothing. WHACK PSHHHHHHHHHH!

    Wiggle all the glass & seal strips out of the channels and savor the extruded aluminum.

    All the glass stays in the sheet for easy disposal, but I always have to hit it harder than you'd think.
    Out of clutter, find simplicity. --Albert Einstein

  6. #4
    eesakiwi's Avatar
    SMF Badges of Honor



    Member since
    Dec 2010
    Location
    NZ
    Posts
    2,531
    Thanks
    2,909
    Thanked 2,556 Times in 1,227 Posts
    If you want a quick quiet way to break Safety glass, use something ceramic to smash the glass.
    The ceramic insulator broken off a sparkplug will do.
    I had heard about this idea & knowing a bit about safety glass ( A friend used to operate the kiln they use to make commercial sheet safety glass ) I tried it out on a old car we were taking to the scrapyard.

    I simply hiffed a chunk of ceramic insulator at the side window and it went 'Piff' & turned crazed, with a hole in it where the insulator went thru.
    Then the crazed glass fell out.

    Ceramic from a broken coffee cup should do, it's the sharp edge that needs to hit the glass to break it.
    It chips the outer 'Under stress layer's of the glass, this weakens it there, which puts stress in other places & suddenly it's stressed thruout the pane. & Boom. It's gone.
    Wear safety glasses always when doing any shifting or work around safety glass. This is important.

    Hopefully this info helps & I hope it's used in the right way & there's the odd chance that in a emergency it might save somebody from some hurt.


  7. Similar threads on the Scrap Metal Forum

    1. Meteor Shower!
      By Sirscrapalot in forum Off Topic Discussions
      Replies: 16
      Last Post: 08-16-2015, 07:44 AM
    2. gross story to make you smile today and take a hot shower
      By travistemple202020 in forum A Day in the Life of a Scrapper
      Replies: 2
      Last Post: 07-27-2015, 04:41 PM
    3. Whats the longest scrap run you have down without a shower/bath?
      By eesakiwi in forum A Day in the Life of a Scrapper
      Replies: 17
      Last Post: 03-17-2013, 05:16 PM
    4. 9 ft long drainage pipes. Will they shatter? How heavy do you think they are? [pics]
      By Backwell in forum Scrap Metal Questions and Answers
      Replies: 34
      Last Post: 02-06-2012, 07:36 PM
    5. Microwave doors
      By Rowdy in forum Scrap Metal Questions and Answers
      Replies: 2
      Last Post: 01-30-2011, 05:42 PM

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

 
Browse the Most Recent Threads
On SMF In THIS CATEGORY.





OR

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

The Scrap Metal Forum

    The Scrap Metal Forum is the #1 scrap metal recycling community in the world. Here we talk about the scrap metal business, making money, where we connect with other scrappers, scrap yards and more.

SMF on Facebook and Twitter

Twitter Facebook