Experienced Scrapper
|
I will post a video of the way I do it in the next couple days. It takes me about 20 minutes to get the copper out of both condencer coils and the I have the good aluminum and good copper. I didnt see this in a post yet so I thought I would bring it up. how do you do it?
Looking forward to the video. I have a few I need to cut apart and haven't found an economical way to do so.
Experienced Scrapper
|
|
my way is sort of violent and makes one hell of a mess but works better than expected. ive tried a torch, uggggg no good. hammer even worse. vice to rip them apart, almost lost a nut there. but thios works well wait and see
Last edited by Silence; 06-06-2011 at 10:08 PM.
Metal Recycling Entrepreneur
|
I'd like to see this, too. I've been turning them in for years as just copper/aluminum coil (cac)
Bummer. He got banned. Really wanted to see his method.
Experienced Scrapper
|
me too Idaho...why did he get banned ?
|
Wondered why he dropped off the face of the earth.
Recyclable Material Merchant Wholesaler
Certified Zip-Tie Mechanic
"Give them enough so they can do something with it, but not too much that they won't do nothing."
|
I must have missed something.
I wanted to see the video. It dawned on me I hadn't seen any new postings, so I went back and looked and noticed he was banned.Originally Posted by Silence
|
|
I looked through his posts and saw nothing. Perhaps it was something bad enough to delete. Either way, I have had no problems so far with the owner/operator of this site and the decisions made. Especially never taking a problem public. Which is always best for any forum.
There are currently 2 users browsing this thread. (0 members and 2 guests)
|
Browse the Most Recent Threads
On SMF In THIS CATEGORY. 
OR 
|
Posting Permissions
Register To Reply
Bookmarks