I just bought a strip meister original drill power. It should arrive by the 18th it says anyone have experience with these? Does it really work with kinked and twisted wires like it showed in the video?. Or did I just bite the bullet with a hunk of junk?. Gotta be better than doing it by hand I have 72lbs of insulated romex to do yet I had a total of 118lbs I did some and got 31lbs bare so far. Going to get some xhhw se cable 6awg close to 1000ft I'd say. Can you do a whole spool of wire on that thing?. Or can it not handle that much at once?. Once I get all the wires done I can move onto ac rads I can break them down faster than I can strip wire haha. I use a sawsall and cut off the loops then pull loops off the steel clean rads are 1.85$ a lb that's the highest I have ever seen.