Multi multi multi fail!!!!
1st fail, Using a hatchets axe face as a chisel. Its to be used as a axe only.
2nd fail, The bashed part is actually a hammer head...
3rd fail, The hatchet heads not on center with the axe face, so when it was bashed, it spun around in the guys hand (the two points where it rotated were the far end of the axe face & where he hit it, making it spin around on that axis)
4th fail, Bashing the hatchets hammer head with a second hammer... OMG, don't you know NEVER bash two hammer faces together.
They are both case hardened & bashing them together 'contains' the forces of the hardened metal.
When the forces mount up, suddenly a part of the case hardened head explodes & shoots off a very hard piece of metal, sorta like a kinetic hand grenade.
You can see where it happened, the sudden spark as it shot off & the guys hand getting pierced by the splinter.
Actually thats a **** good example of it, I have heard of someone getting a 1 inch long splinter up completely under their fingernail.... Ouch!
Its also the same reason you regrind the head of a chisel back when it starts to mushroom out.
Hope he was wearing safety glasses.
5th fail, No gloves. Ok I don't use them either, but thats because I can't fit them on my hands. Too hard to explain ATM.
Same reason I type with two fingers.
6th fail, Well technically.... You should probably use a larger hammer here, like a 5Lb hammer.
less bashes = less chance of something bad happening. Thats a carpenters hammer, used for bashing tiny nails, not chisels.
7th fail, Well in the end (or start) you don't need a chisel, just upend the transformer so its got one edge on the ground & the part he's bashing up in the air, then bash across that corner edge. (I'm talking about microwave transformers here).
Thats where I do use a carpenters hammer.
With the smaller hammer & what I'm doing, is too loosen the end plates laminations & weaken the weld, then I flip it around & do the other end of the laminations & by then the welds cracked & I can see where its cracked.
The laminations come off in chunks, but I need those chunks to prop out the whole transformer later & to use as a punch to bash the Copper coils off the 'E's. (I'm doing this on a footpath, where I found the microwave.... less tools to carry).
8th fail, Ahhhh Aluminum wires? Shoulda checked both windings first... Thats like 380 grams of Ali there, worth, ah,
NZ 40cents..... = US$0.32cents
9th (maybe) fail, Just peel off the insulation around the windings, it saves space & looks better. The cardboard peels off & the glue chips off & what you can't get off after a proper cleanup like that, is just wasting time considering the actual amount of waste material left on the coil.
10 (maybe) fail, That iron cores made of Iron, not Aluminum. But I know what he ment.
Bookmarks