Part Time Scrapper

[MattChance]

Hey people. I've been scrapping for 2 years now, and have thus far made $3,700 and counting. It makes me a little sick to my stomach to think about the many years I lived before I knew you could make so much money off of scrap so easily.

The best-paying haul I ever got to take was from my company deciding to get rid of old stock - I made $255 on a single trip with a trunkload containing 137 Lbs of clean Brass.

I don't always have high quality scrap, in terms of cost, but the business I work for has bulk steel that is constantly rolling through. I get really excited when I nab a piece or two of copper and brass, which I never thought I'd say. I wish I knew a way to come across the higher cost stuff easier, but sites like this definitely give me some ideas.

My coworkers don't scrap, and always tease me for grabbing little nuts and bolts left lying around, but they don't get that it's a great way to make side money.

I have a question about the forum, longterm users here may be able to answer. I like the "Linear" thread display for when you open a thread up to read it - but when I do so, it shows me the newest post at the top of the page. I'd prefer to see the oldest thread post first, and then read through the responses. Is this possible on this forum? That's the way I always like to have my view set-up.

[MattChance]

Thanks, got it fixed right away!

[KzScrapper]

Welcome to the forum.

[MattChance]

Thank you KZBell. Lots of interesting stuff to read here, and hopefully learn some things from.

I like your signature! That's usually my solution to any problem, much more so than duct tape.

[miked]

Welcome to the forum. I like the money and adventure of breaking down items to get to the goodies. There's lots to learn here so take the time to read the old threads it will pay off.

Where is Denver, NC? I am in Jacksonville, NC on the coast near Wilmington. Mike.

[corycouch]

welcome

[Dumpster-Dee]

welcome Matt. Sounds like you are off to a great start. Keep reading the old threads and you'll be glad you did.

[MattChance]

Welcome to the forum. I like the money and adventure of breaking down items to get to the goodies. There's lots to learn here so take the time to read the old threads it will pay off.

Where is Denver, NC? I am in Jacksonville, NC on the coast near Wilmington. Mike.

I was looking at one thread here questioning how to take a type of motor apart, and realized it was the exact same thing I struggled with a year ago. If I had known about this forum then, it would've been a big help. So the older threads definitely do help. I have a lot to sit down and read

Denver, NC is just outside of Charlotte, bordering the bigger towns of Huntersville/Mooresville/Mount Holly.

[skipRAT]

Hello and welcome to the forum Matt
The forum is a wealth of information, read as much as you can not forgetting the older posts, as the advice starts there!

I don't always have high quality scrap, in terms of cost,

Only the very lucky get good quality scrap all the time, and them type of people are few & far between mate.

I get really excited when I nab a piece or two of copper and brass,

Yeah im the same haahaha

My coworkers don't scrap, and always tease me for grabbing little nuts and bolts left lying around, but they don't get that it's a great way to make side money.

Dont worry mate, the money is in your pocket not theirs...who's laughing now!
Just remember that when you are picking up nuts & bolts
Be Lucky