My setup not the best but it works for me

**Bear** · 12-02-2012, 10:31 PM

welll hek, it was first thing on the list and I went right by it.
On your door there's codes for everything, mine had a payload number somewhere though, I don't see that here on yours, it does have specs for WB, GVW, TRANS, AXLE and Springs though, if you want to know any of those, get the code off the door for them ( it's the number/letter spec under each category)

**ilovejunk** · 12-02-2012, 10:50 PM

if your trying to look up, your vehicles specs, rpo codes ect. i have had good luck with this site, works for alot of different models.

Comprehensive Chevrolet, Saturn, GMC, Hummer, Cadillac, Buick, Oldsmobile, Pontiac, Geo, Dodge, Plymouth, Jeep, Chrysler, Ford, Lincoln, Mercury, Mazda Truck, Mercedes VIN Decoder

**pcscrapper** · 12-03-2012, 03:49 AM

Hey that looks great.. nice rig, You'll have lots of sucess with that rig.

**greytruck** · 12-03-2012, 12:46 PM

I got that same wire stripper also. I wish there was one more size bigger on it tho

**taterjuice** · 12-03-2012, 01:52 PM

Nice setup ! I sure it works well for you and that's the most important part. I'd say a pickup bed trailer like the ones I build would benefit your operation greatly. I'd suggest this before getting a car trailer.

**taterjuice** · 12-03-2012, 01:57 PM

A link to my write up on pickup bed trailers. http://www.scrapmetalforum.com/tools...d-trailer.html

**mikeinreco** · 12-03-2012, 02:38 PM

As far as hauling a trailer around I don't like it either......Your truck can go so many places that trailer can't.......Although it is nice to have the trailer when you have to pick up a large LOAD!!!