Recovering gas EFI style

Thank god for electric fuel injection, makes getting gas from salvage autos a snap. This is just a general run down and not meant to be a step by step guide.
Locate schrader valve on the fuel rail and remove the core, looks like a valve stem on a tire. Slide a 2-3' length of 1/4" fuel line over the valve and secure with hose clamp


Locate wires that run the pump, usually over rear seat or in this case in the trunk


Next the tricky part, determine which is the two wires you need to make the pump run, this ford uses pink/black stripe for 12v (+) and black for ground.


Connect your wires and put your 1/4" fuel line into your fuel container of your choice and let it pump

This old crown Vic had almost 10 gallons in it or 33.40$ worth of gas.

That's another way of doing it, more than one way to skin this cat. I do for this method because it's the simplest way I can think of. On gm cars it's a purple/ grey wire and a black for ground, I think. In any event there's usually 3-4 wires running to a fuel tank I pick the biggest two and try em tell I hear the pump start, most times black or a darker color is ground.
Wished that guy would've filled up before he hit that deer.

Or worse sucking on gas hose to siphon it

I don't like the hole/ drain pan method because it's a gassy fuel wasting mess but to each his own.

I just lower the car close to the floor (i have a hoist so that helps alot) drill a big hole with my air drill, get a jerry can with a huge funnel, no mess, and very quick to drain. My first time doing it was very messy though I must say LOL my scrap yard won't take em unless the tank has a hole in it anyways.