scrap a forklift

Hey I have two old gas forklifts and could use some advice on how to do it and what to sell off them.



thanx, ben

Dixon Towing

depending on condition they may be worth more as a fork lift than for scrap, depending on age and what engine is in them someone may want the engine.

a few months back I cut up three truckloads of drivable running fork trucks the market is flooded with them and whoever bought the lot at auction determined they werent worth sitting on. The scrap yard pulled out two of them and they ran like a champ and the rest got cut up the market for resale is flooded for solid tire small lifts. These things were good looking to anyhow are u going to sell them whole or cut them up and prepare them. Breaking them down will result in HMS and a solid cast iron counter weight. You can't get P and S for any of it the chemisty isn't right because it has hardening alloys in it. Beware the side pockets contain gas or diesel in one side and hydraulic fluid in the other and all of the hydraulic lines will be full of oil so drain them and try not to injure yourself cutting them up drain the lines and tanks and have at it. Good luck.

Can I make money from my forklift that is not use? scrap or what else I can use from it?


--------------------------------

On a forklift, Definatly pull the batteries and the forks. The rest would go as Unprepared Steel at most yards. Let them cut it up, you'll make more in the long run that way.

Originally Posted by 1towman

Hey I have two old gas forklifts and could use some advice on how to do it and what to sell off them.

thanx, ben

Dixon Towing

I have a old ac fork lift I was going to sell for parts it's still setting in shead after 4 years. You might be able to do better than I did good trans new tires. Rebuilt cylinders. Next time I get some time it's scrap yard bound.

Originally Posted by MDJSalvage

On a forklift, Definatly pull the batteries and the forks. The rest would go as Unprepared Steel at most yards. Let them cut it up, you'll make more in the long run that way.

Save the pump forks battery some of the frame for firewood splitters cylinders front lift frame. Transmission got lot of alum. In it brass clutch plates. Save the tires might come in handy later

I've been looking for a decent little forklift for cheap...anyone near terre haute, indiana have one?

I have this propane forklift for sale (on consignment from a customer). Everything works, no leaks,
I don't see a categorie "equipment" on Craiglist.
What's the best way to advertise it?
Thanks